
12 Model 161Operating Procedures
Step 3
Place the large o-rings into the grooves on t he back of
the machine door and lubricate.
Figure 6
Step 4
Slide the front bearings over the baffle rods so the
flanged edge is against the door. Place the white
plastic guide bearings on the end of the baffle rods.
Figure 7
DO NOT lubricate the front bearings or the guide
bearings.
Step 5
Install the freezer door. Insert the hands crews into the
slots in the freezer door. With both hands, hold the
sides of the freezer door and insert thebaffle rods into
the center of the beater assem blies. The white guide
bearings must fit securely in the holes of the drive
shafts. Finger-tighten the hands crews equally to
insure that the door is snug. Do not over-tighten.
Figure 8
Note: The freezer door is in thecorrect position when
the door spouts are on the bottom.
Step 6
Slide the two o-rings into the grooves on the draw
valves and lubricate.
Figure 9
Step 7
Install the valve seal in the grooves on the center draw
valve and lubricate. This special seal will prevent mix
from one freezing cylinder from t raveling into the
second cylinder.
Figure 10