3
Model 161 Safety
040211
Section 3 Safety
Weat Taylor Company are concer ned about the safety
of the operator when he or she comes in contact with
the freezer and its parts. Taylor has gone to extreme
efforts to design and manufacture built-in safety
features to protect both you and the service technician.
As an example, warning labels have been attached to
thef reezer to further point out safety precautions to t he
operator.
IMPORTANT -- Failure to adhere to the
following safety precaut ions may result in severe
personal injury. Failure to comply with these
warnings may damage the machine an d its
components. Component damage will result in
part replacement expense and service repair
expense.

To Operate Safely:

DO NOT operate the freezer without reading
this operator’s manual. Failure to follow this instruction
may result in equipment damage, poor freezer
performance, health hazards, or personal injury.
SDO NOT operate the freezer unless it is
properly grounded.
SDO NOT operate the freezer with larger
fuses than specified on the freezer data
label.
SDO NOT attempt any repairs unless the
main power supply to the freezer has been
disconnected.
Failure to follow these instructions may result in
electrocution. Contact your local aut horized Taylor
Distributor for service.
DO NOT use a water jet to clean or r inse the
freezer. Failure to follow these instructions mayresult
in serious electrical shock.
SDO NOT allow untrained personnel to
operate this machine.
SDO NOT put objects or fingers in door
spout.
SDO NOT operate the freezer unless all
service panels and access doors are
restrained with screws.
SDO NOT remove the freezer door or beater
assembly unless the control switches are in
the “OFF” position.
Failuret o follow these instructions may result in severe
personal injury from hazardous moving parts.
USE EXTREME CAUTION when removing
the beater assembly. The scraper blades are very
sharp and may cause injury.
This freezer must be placed on a level
surface. Failure to comply may result in personal injury
or equipment damage.
DO NOT obstruct air intake and discharge openings:
A minimum of 6” (152 mm) on both sides, and 0” in the
rear is required. Install the skirt prov ided on the right
side of the unit. Failure to follow this instruct ionmay
cause poor freezer performance and damage to the
machine.
This freezer is designed to operate indoors, under
normal ambient temperatures of 70_-- 7 5 _F
(21_-- 2 4 _C). The freezer has successf ully performed
in high ambient temperatures of 104_F(40_C) at
reduced capacity.
NOISE LEVEL: Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor.