Taylor 2753 Table of Contents, Battery Installation, How to Set Up Your Rain Gauge

Welcome to the Taylor® Digital Wireless Rain Gauge and Thermometer. Simple, reliable, accurate… it allows you to monitor indoor or outdoor temperatures as well as rain fall from one room. While the base unit reads indoor conditions, the remote sensor wirelessly reports outdoor weather conditions back to the base unit for an all-in-one weather display.

Plan your work day, play day, every day. Now that's smart!

Table of Contents:

Battery Installation	2	Temperature Readings	6
How to Set Up Your Rain Gauge	2-4	Temperature Trend Indicators	6
Where to Place Your Rain Gauge	3	Temperature Alerts	7
How to Display Your Rain Gauge	3	Low Battery Indicators	7
How to Read Your Rain Gauge	5	Trouble Shooting	7-8
How to View Readings	5	Precautions	9
Rain Alert	6	Specifications	8
Rainfall History	5	Warranty Information	9

Battery Installation

Base Unit:

The Base Display Unit is powered by 2 AAA batteries (not included).

1.Remove the battery compartment cover located on the back of the unit.

2.Install 2 AAA batteries.

3.Replace the battery compartment cover.

4.Remove any static cling label from the LCD screen. Important: Install batteries in the base unit before installing batteries in the rain cup sensor, or the units' transmissions may not properly connect.

Rain collection cup sensor:

1.Remove the 2 screws from the battery compartment cover on the bottom of the rain collection cup sensor and remove the cover.

2.Install 2 AAA batteries (not included) into the battery compartment.

3.Tip: Lithium batteries are recommended in extremely cold or hot locations.

4.Replace the battery compartment cover and the screws. Make sure the door is securely closed to prevent water leakage.

Base Unit

UP		MODE	DOWN
IN-OUT	ALERT	RE-SYNC		HISTORY
TEMP

Remote

Rain

Collection

Cup

How to Set Up Your Rain Gauge

1.Remove any static cling labels from the LCD screen and any tape from the base unit or rain collection cup.

2.Install 2 AAA batteries into the base unit (see Battery Installation section).

3.Install 2 AAA batteries into the rain collector cup sensor (see Battery Installation section).

4.Remove the 2 screws on the bottom of the rain cup sensor and remove the rain cup cover.

5.Remove any tape or cardboard from the rain cup pendulum to allow it to fill and empty when rainfall occurs.

6.Replace the rain cup cover and the 2 screws.

ry

er tt e

Ba ov

C

Tape or Cardboard

2