Taylor 2753 instruction manual Trouble-Shooting continued, Specifications, Transmission Collision

Trouble-Shooting (continued)

Transmission Collision

Signals from other household devices, such as doorbells, home security systems and entry controls, may interfere. This is normal and does not affect the general performance of this product. The transmission will resume once the interference recedes.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

Modifications not authorized by the manufacturer may void users authority to operate this device.

FCC ID: VVG53631638TX

Problem Solving

1.If the LCD readout on the base unit is faint, replace the batteries.

2.If outdoor temperature does not display on the base unit:

a)Remove and reinstall all batteries;

b)Use fresh batteries;

c)Place the rain collection cup sensor closer to the base unit;

d)Position the base and rain cup sensor so that the transmission path is free of any obstacles, such as buildings, trees, etc. Try to have no more than 2 or 3 walls

between the units.

3.If synchronization is lost between the base unit and remote sensors:

a)The base unit displays “--.-C” or “---.in”.

b)Press “RE-SYNC” on the base unit.

The base unit will search for the rain cup sensor signal for 3 minutes. If the outdoor temperature does not display after 3 minutes, press “RE-SYNC” again. If attempts to synchronize fail, check that there are no physical obstructions between the units that might block transmissions, such as sheds or trees. If necessary, shorten the distance between the receiver and remote units. Remove all the batteries from the units, wait at least 10 seconds, and then install the batteries again. Repeat Set-Up instructions to re-synchronize the units.

Specifications

•Range of temperature measurement:

Base unit (indoor only): 14°F to 158°F (-10°C to 70°C)

Rain collection cup sensor: -4°F to 158°F (-40°C to 70°C)

•Resolution: 0.1 degree for temperature

•Transmission frequency: 433 MHz

•Temperature trends: rising, falling or steady

•Minimum/Maximum: temperature/rainfall records

•Clock: 12 or 24 hour

•Low Battery Indicator

•Transmission: Max. 100 ft (30m) open area

•Power: 2 AAA alkaline batteries (not included) for base unit and 2 AAA alkaline batteries for rain cup collector (not included)

8