TC electronic SDN BHD DVR2 manual Focus Fields, Overload Indication O/L, To change the assignment

you can always save your session without losing any of the plug-in settings. The last setting of the plug-in will always be saved, even when it is in “disabled” state! This also applies to saving presets.

FOCUS FIELDS

You can place your own set of parameters in the 6 focus fields at the bottom of the plug-in. Making use of the focus fields can give you a better workflow, since you will not have to switch pages all the time to find the parameters that you work with. You can assign any parameter to the focus fields, and the focus fields are stored with the session as well as when you save your presets.

To change the assignment:

•Press the Assign button. The Assign button as well as one of the Focus Fields will be highlighted.

•Select the Focus Field you wish to link a parameter to, by clicking on that field.

•Click on the parameter you wish to link to the selected Focus Field.

•To get an unassigned (empty) Focus Field, click again on the selected parameter.

•Once you have finished the assignments, click again on the Assign button to leave the assign mode.

OVERLOAD INDICATION (O/L)

The O/L-LED in the metering section, on the left side of the input meters, will light up in case internal DSP overloads are detected. You should lower the input level to avoid

these overloads. To reset the indication, click on the O/L LED. HS

IL

GN

E

DVR2 / 7