Mode
Rate Mode - This is where you decide what basic layout of the
grid you want to work with. There are three different setups:
1) Two channels with four processing positions on
each channel (44.1/48kHz)
2) One processing position on both channels.
(88.2/96kHz)
3) Three processing positions on Ch.1 and none at
Ch.2 (88.2/96kHz)
The difference between the three modes is, that the processing
sample rate in the first mode is 44.1 or 48 kHz, where it is 88.2
or 96 kHz in the other two modes. The arrow boxes on each side
of the processing blocks indicates the up and down sampling of
the signal.
NOTE: In mode three there will still be signal through channel
two, and you still have the M/S matrix, Delay, Insert and the
processing on the front available (Locut/Softclip).
Ch.1 to Ch.2 -
23
EDIT - Routing and Layout
This is a built in Y-split that enables you to get channel one’s
input signal on both processing lines. You can select whether the
signal should be taken before (Pre) or after (Post) the processing
blocks of channel one. The post setting actually enables you to
use all eight processing blocks at 44.1/48 kHz Mode in a serial
way for channel one’s input.
NOTE: The signal for Ch.2 will be taken right after Locut and
Softclip, but before Phase Invert. Therefore Locut and Softclip
will be set to Off on Ch.2, but Phase Invert will be available on
both channels.
The M/S Matrix will not be available because M/S recording
needs two separate inputs.
In the Post mode Links will not be available.
Insert -
With this parameter you select if you want to have the Insert
block present in the Routing grid, and if it should be placed
before (Pre) or after (Post) the processing blocks.
NOTE: You have to select the send/return source on the Signal
page.
Columns and Blocks
The functions here are somewhat similar to the functions of a
spreadsheet. Use them when you want to move, insert or delete a
whole Column or a single Block.
Column -
Move Left - Will move the current Column to the left.
Move Right - Will move the current Column to the right.
Insert Col - Will insert a new Column.
Delete Col - Will delete the current Column.
Block -
Move Left - Will move the current Block left.
Move Right - Will move the current Block right.
Insert Block- Will Insert a new Block.
Delete Block- Will delete the current Block.
Press Enter to carry out the selected function.
Insert
placed
post
processing
Ch.1 input
to Ch.2,
post
processing