Before You Begin

Congratulations on your purchase of the TDK Systems blu2i Module.

The Module is designed to be built into a device and to provide a simple, low cost Bluetooth interface. The module is designed to integrate with a wide range of applications and platforms with a simple electrical and software interface using AT commands.

This guide aims to provide all the electrical and mechanical information needed to design applications using the blu2i Module. A separate document, blu2i Module - AT Command Set, outlines the protocol for the software interface.

Safety Guidelines

The following safety precautions must be observed during all phases of the operation, usage, service or repair of any application incorporating this Bluetooth Module. Manufacturers of the RF equipment are advised to convey the following safety information to users and operating personnel and to incorporate these guidelines into all manuals supplied with the product. Failure to comply with these precautions violates safety standards of design, manufacture and intended use of the product. TDK Systems assumes no liability for customer failure to comply with these precautions.

RF Approvals

The blu2i Module is listed as a Bluetooth Product in terms of the Bluetooth SIG Program Reference Document (PRD). This means that it can be integrated into end products without further testing or approval listing. The manufacturer must state the TDK part number and product reference in his literature in order to meet the requirements of the Bluetooth and regulatory approvals.

A list of the countries where the module is approved will be provided by TDK Systems as required. As a minimum the product is listed in Europe, Scandinavia and USA. TDK Systems assumes no liability for customer failure to comply with national RF approvals.

3 of 36