Output Settings, Link, DF Digital Filter

Output Settings

PLAY AREA .//

1In the stop mode, press and hold the PLAY AREA button for more than 2 seconds.

The unit enters setup mode, and “ >***” appears on the display. (*** changes depending on your setting.)

In the following cases, the setup mode will be cancelled:

•Leave the unit idle for 10 seconds.

•Press and hold the PLAY AREA button for more than 2 seconds once again.

2Repeatedly press the PLAY AREA button to select the menu item to be changed.

i.LINK DF DSD

(normal display)

3Use the SKIP buttons (.//) to select the options within the menu item.

4Press and hold the PLAY AREA button for more than 2 seconds (or leave the unit idle for 10 seconds) to exit the setup mode.

<Switching off the power without exiting the setup mode may cause problems. Do not turn the unit off.

<Settings are stored even when power is turned off and the unit is unplugged. If left unplugged for an extended period, the settings may be lost.

Used to select an i.LINK output setting. “60958”, “PCM” or “OFF” are available.

You can also use the i.LINK button of the remote control unit. See page 14 for details.

Used to select a digital filter. “Wide” or “Narrow” are available.

Select “Normal” to output DSD after processing and “Direct” to output the audio signal without running it through the processor.

The analog level in the Direct mode is 3 dB lower than in the Normal mode.

Select this to exit the setting mode.