Teac X-01 Repeat mode, Display dimming, Analog sound output, Track repeat, Disc repeat

Repeat mode

Use the REPEAT button to select the repeat mode for playback. Repeated presses of the REPEAT button cycle between the following options:

REPEAT TRK	REPEAT DSC
(track repeat)	(whole disc repeat)

REPEAT OFF (no repeat)

<Halting playback stops the repeat mode.

<This feature is not available for all discs.

<The following buttons cancel repeat mode:

STOP, OPEN/CLOSE, POWER.

Track repeat

When this is selected, the currently-selected track repeats. If another track is selected during repeat playback, the newly- selected track repeats.

Disc repeat

The whole contents of the disc are repeated.

Programmed repeat

If programmed playback has been set up, the whole program is repeated.

Pushing the REPEAT button cycles between REPEAT PGM (program repeat) and REPEAT OFF (programmed playback takes place).

Display dimming

The display on the main unit can be dimmed to suit the environment in which you listen to music. There are three levels and an “off” setting.

Use the FL DIMMER button to cycle between these settings.

and then turned on again, the display is reset to the minimum	ENGLISH
Note that the OFF setting is not memorized when the power is
turned off. When the unit is switched off with the display off,
brightness.

Analog sound output

When playback is stopped, use the 2CH/MULTI button to select either 2CH (stereo) or MULTI (multi-channel surround) audio output from the analog outputs.

Note that if multi-channel program material is played and 2- channel mode is selected, the multi-channel material will be downmixed to two channels, and output through the L and R front outputs.

<This setting is also reflected on the setup menu.

<5.1CH indicator lights when “Multi ch” is selected.

15