SpeedTouch 210i
34
♦ Password – Specify a password for authentication by the remote router.
♦ Dial Number – Specify the destination ISDN number for dialup.
♦ Scheduler (1-15) – Enter up to 4 index numbers for calls that have been
previously configured on the Call Schedule Setup windows (under Advanced
Setup).
♦ Link Type – Indicate the dial-out link type.
 Disable: Deactivate the dial-out action.
 64kbps: Specify the outgoing connection speed is restricted to 64kbps
(one B-channel).
 128k bps: Specify the outgoing connection speed is 128kbps (two B-
channels).
 BOD: Specify the link type to be dynamic bandwidth control
(Bandwidth-on-Demand).
♦ PPP Authentication – Specify the authentication method. Normally set to
PAP/CHAP for the widest compatibility.
♦ VJ Compression – VJ Compression means TCP/IP protocol header
compression. Normally set to "On" to improve band-width utilization.
♦ Callback Function (CBCP) – The callback function is implemented by the
CBCP protocol that is one of the PPP protocol suite.
Require Remote to Callback - Inactive by default. When active, the
router exchanges connection information with the remote router and
requires the remote router to call back to make a connection.
Provide ISDN Number to Remote - In some cases, the remote router
requires the ISDN number for calling back. Check here to allow the local
router to send the ISDN number to the remote router. The remote router
owner will be charged the connection fee by the telecom.
Dial-In Settings
♦ Username – Specify an username to authenticate the dial-in router.
♦ Password – Specify a password to authenticate the dial-in router.
♦ Enable CLID Authentication – Limit the dial-in router to be called from a
specific ISDN number.
♦ Peer ISDN Number – If CLID Authentication is enabled, enter the remote
router's ISDN number in this field
♦ Link Type – Refer to Dial-Out Settings.
♦ PPP Authentication – Refer to Dial-Out Settings.
♦ VJ Compression – Refer to Dial-Out Settings.
♦ Callback Function (CBCP) – Checking here allows this router to accept
requests from a remote router for call back.
 Enable Callback Function - Checking here to enable this function. The
router owner will be charged the connection fee by the telecom.
 Use the Following Number to Callback:
- Callback Number: Check here and enter a callback number for
the router to call.