Using the Remote Control
USING THE CODE-ENTRY METHOD TO PROGRAM YOUR TV REMOTE
Now that you have looked up the four- digit
for your brand of accessory device, you are ready to follow the simple steps shown below to program your TV remote.
Please read through all the steps before beginning.
1 First, press and hold down the VCR or ACC (for an accessory device other than a VCR) mode button on the TV remote. Then press and hold down the MENU/SELECT button at the same time for a brief moment. Release the buttons. The TV remote back light will switch on.
NOTE: For correct operation, you must first press and hold the mode button and then press and hold the MENU/SELECT button simultaneously.
2 Within 30 seconds of pressing the VCR (or ACC) button and MENU/SELECT button, enter a
If you make a mistake while attempt- ing to enter the
3 Point the remote at the accessory device. Then press the POWER button on the remote to turn the device on.
HELPFUL HINTS
•If you do not enter a complete code within
30seconds, you will need to perform step
1of the
•If you enter more than four digits, the unit will retain the first four digits entered.
•If the procedure explained above does not work the first time, repeat the steps using the same remote code number.
•If after a second try the remote does not operate your accessory device, and more code numbers are listed for your brand, use the next listed code number.
•If after repeated attempts the
Satellite Receiver
Cable Converter Box
DVD Player
VCR
1 |
| POWER |
|
|
| 3 | |
TV | VCR | ACC | |
SWAP | PIP CH | ACTIVE | |
CONTROL | |||
DN | UP |
|
|
SOUND |
| PICTURE | 1 |
STATUS/ |
| MENU/ |
|
EXIT |
| SELECT |
|
2 VOL | MUTE |
|
|
| CH |
|
1 2 3
4 5 6
7 8 9
TV/VCR
A/CH | 0 | SURF |
POSITION |
| PIP |
19