Connections and initial set up
Programming the remote control
If your remote control does not control your satellite receiver (or cable) or your television set you will need to configure it using one of the two methods proposed: automatic code search or manual programming.
SAT Codes: 5000, 5001, 5031, 5037, 5043, 5064, 5065, 5066, 5058, 5084.
TV Codes: 1000, 1001, 1002, 1016, 1024, 1033, 1041, 1051, 1089, 1096, 1127, 1128, 1129, 1130, 1134, 1135, 1148, 1151.
VCR Codes: 2000, 2001, 2063, 2074, 2091, 2098, 2099
AUDIO Codes: 4003,4007
Automatic code search
This method can be used to automatically find the most appropriate code for | EN |
your appliance. |
1.Switch on the appliance you wish to use the remote control with.
2.Press the relevant button for this appliance on the remote control, and while holding this button down, press theB standby button until the remote control light comes on. Release the two buttons.
3.Point the remote control at the appliance and press PLAY.Wait until the light stops flashing. If the appliance has not gone into standby mode after five seconds, press the PLAY button again to continue the search for the next set of codes. Repeat this operation until the appliance goes into standby mode.There are 20 sets of codes.
4.When the device changes to standby, press the standby button B on the front to switch it back on again.Then press the REV key to set it to standby again and, if necessary, retry until the device changes to standby.
5.Press the STOP button and hold it down until the remote control light goes off.
Manual programming
This method involves carrying out a manual search for the codes to be used for controlling your other appliances.
1.Switch on the appliance you wish to use the remote control with.
2.Press the corresponding key on the remote control, while holding it pressed down, enter one of the codes corresponding to the make of the device (Thomson Group codes on the bottom left of this page, other brands can be found in the “Related documents” leaflet).
If the remote control light flashes you have entered the wrong code or it is not possible to program the remote control.
3.Point the remote control at the appliance and press the relevant button. Press the B.
If the appliance does not go into standby mode, try another code.
Depending on the year of manufacture and the type of appliance, some functions may not be available.
Certain codes may cover more functions than others. Test the functions you can control and, if appropriate, try other codes.
Note: when you change the remote control’s batteries, remember to reprogram it.
25
