Technicolor - Thomson ITC008 manual About the TV set, Channels Organisation

ITC008_en 3/03/03 16:33 Page 4

About the TV set

Prior to enjoying your TV set, you’ll have to set it up, i.e. to find and store the channels, which may be received in your area. The Automatic Channel Set-up will look for all the channels and number them. Since the channel numbers assigned to the programmes by the Automatic Channel Set-up do not necessarily correspond to the actual number of the channels (example: Channel 4), you may change them upon completion of Automatic Channel Set-up.

How to switch on the set?

With the On/Off-button fitted on the set. When the red LED is lit, the TV set has previously been switched on standby with the key B on the remote control. To switch the TV set on again, type in a channel number.

Automatic Channel Set-up

With the Automatic Channel Set-up

•When a VCR or satellite receiver is connected to the aerial socket, you must switch on this equipment. Should external equipment be connected to the TV set via the SCART socket, it must be turned off.

The first time you switch your TV set on, the automatic installation (AUTO INSTALL.) will automatically appear. If it does not, you will find this menu by pressing a number of times on the remote control MENU key:

- 2 times for the mono TV sets. - 3 times for the stereo TV sets.

The installation menu (INSTALL.) is displayed and the Auto. Install. line is selected.

Press the ok key on the remote control unit to display the AUTO. INSTALL menu.

The first line (Norm.) is selected.

•Depending on the model of your TV set, you’ll have to select from the options listed below the one that fits with your country:

EURO	: Western Europe, Tunisia, Morocco,
	Australia, New Zealand.
FR	: France, Luxemburg.
UK	: United Kingdom, Eire,
DK	: Eastern Europe, Middle East, Africa,
	French DOM-TOM, Asia.

Select corresponding option by means of the directional keys Left/Right.

•Select the Start line through the Up/Down directional keys.

•Start the Automatic Channel Set-up by pressing the ok key.

Two new lines appear showing the frequency and programme number on which each new channel found is memorised.

Wait a few minutes until the Channel Organisation menu (ORG.) appears.

Channels Organisation

The PR line is selected.

How to change the channel number?

To identify each channel, make use of your TV magazine to find out the actual name of the current programme/channel.

1.Use the key PR+ and PR- to select the channel number you wish to change.

2.Press the new channel number (compulsorily 2 digits, for ex.: for Channel 2, enter 0, then 2) on the remote control. You can also use the directional Left/Right keys.

3.Validate with key ok.

The corresponding programme is now stored under the new channel number.

How to delete a channel number?

Delete any programme the picture quality of which appears to be poor.

1.Select the channel with the key PR+ and PR-.

2.Select line using the Up/Down directional keys.

3.Press and hold down the ok key: the channel is deleted.

Prior to leaving the menu, you should check whether the programmes are stored in the order you prefer.

Once your channels are duly sorted, close the menu through EXIT.

You may recall this menu by pressing the MENU key:

-2 times for the mono TV sets,

-3 times for the stereo TV sets.

Note: For channels diffusing teletext in Czech, Slovak, Rumanian, Croat, Russian or Greek.

After having tuned in the channel, display the manual channel set-up menu (see page 5).

-Select the Text line by pressing 5 times on the Down button of the remote control.

-Select the number of the character table, using the table on page 7.

-Memorise it with ok and then quit the menu with EXIT.

4