MS6000 EN 4/2/03 3:14 PM Page 7
Getting Started
Unpacking the system:
You should have the following:
•one main unit (with 2 main speakers);
•one remote control;
•one AM loop antenna;
•one FM antenna wire
•one user’s guide;
•One Thomson Warranty Card
Back View
1
5
2 
3 
4
1.AM Loop Antenna Jacks
2.FM Antenna Connector
3.Aux out Connectors
4.Main Speaker Jacks
5.Optical Out Connector
Using the FM and AM Antennas
Before you use your audio system, you’ll want to make sure both the FM and AM antennas are posi- tioned properly. Connect the FM antenna to the FM connector on the back of the unit. Uncoil it, making sure it is fully extended. (you may even want to tape it to the wall behind the unit if possible. The higher the better.)
You’ll also need to connect the AM antenna loop to the back of the unit if you listen to AM stations. Rotate the AM loop antenna for better reception.
Connecting the Speakers | EN |
|
Match the red wire (on the left speaker) to red termi- nal for the left speaker (L) on the back of the unit and the black wire (on the left speaker ) to the black ter- minal for left speaker (L). Follow the same procedure to connect the right (R) speaker.
Antenna and Speaker Wire Connection
Push terminal tab down to | Release tab to lock wire in |
insert wire. | the terminal. |
NOTE: Make sure the insulation is completely removed from the ends of the Antenna and speaker wires at all connection points.
Installation
To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:
| 10 cm |
|
10 cm | 5 DISC CHANGER | 10 cm |
|
Front View
10 cm
5 cm
Side View
2
