Technicolor - Thomson RCR311B manual Code Retrieval

Programming Methods (continued)

REVERSE ON•OFF

(BLINK)

FORWARD

STOP

ON•OFF

9.When your component turns off, you know the correct code is in the last block of 10 codes sent. Press and release the REVERSE key. Wait two seconds to see if your component turns on again. If your component does not respond, continue to press the REVERSE key every two seconds until your component turns on again. This will isolate the correct code in the last block of codes sent. Each time the REVERSE key is pressed, the illuminated ON•OFF key blinks.

Note: If you accidentally press the REVERSE key after your component responds, press and release the FORWARD key. Then, wait two seconds to see if your component turns off again.

10.Once your component turns on, you have found the correct code. You must save the new code by pressing and releasing the STOP key. The illuminated ON•OFF key turns off.

You must press the STOP key

to save the code or the correct code will not be stored!

11.To confirm that the component key is programmed with the correct code for maximum functionality, test the component. Attempt to control a variety of the component’s functions with the remote. If some of the features of your components do not work, try programming the remote with a different code in the list until you find the code that allows the remote to control the majority of your component’s functions. Different codes can provide different levels of functionality.

12.Remember to enter the codes for future reference in the boxes provided with Code Retrieval section on pages 10 and 11.

Code Retrieval

Once you’ve programmed the remote to control your components, you may want to record the codes for future reference. If you used the Direct Code Entry method, this is easy. Just find the codes you programmed in and make a note of them in the boxes below. If you used one of the Code Search methods to program your remote, you will need to retrieve each component’s four-digit code. Retrieving the actual code and writing it down will save you time if you ever need to program the remote again (e.g., if programming is lost when you change the batteries). If the codes are recorded, you can use the Direct Entry method to reprogram your remote to control your components, which is quick and easy.

VCR•DVD 1.

TV SAT•CBL

ON•OFF

Press and hold the component key (TV, VCR•DVD, SAT•CBL) whose code you wish to retrieve. The illuminated ON•OFF key turns on.

INFO

ON•OFF

2.While holding the component key down, press and hold the INFO key. The illuminated ON•OFF key turns off.

3.After holding down both keys for three seconds, the illuminated ON•OFF key turns back on.

10