Technicolor - Thomson RCR311B manual To program the remote to control a VCR or DVD

Brand Code Search key (TV, VCR•DVD, SAT•CBL, ON•OFF, GO BACK, and number keys 0-9), the search times out after two minutes. When the search times out, the illuminated ON•OFF key blinks four times and turns off. The last programmed code under that component key is retained.

3.If you are programming the remote to control your TV, satellite receiver or cable box, go directly to step 5.

4.To program the remote to control a VCR or DVD. The

VCR•DVD key can control only one component, either your VCR or your DVD. To program your remote to control either your DVD or your VCR, you must first put the remote in the proper programming mode. Follow these directions before proceeding to step 5.

VCR•DVD ON•OFF

VCR•DVD

VCR•DVD ON•OFF

(BLINK)

VCR•DVD

a.Press and hold the VCR•DVD key. The illuminated ON•OFF key turns on.

b.While holding down the VCR•DVD key, press and release the number 2 key on the keypad to control a VCR or the number 3 key to control a DVD. The illuminated ON•OFF key blinks, and then turns back on.

c.Release the VCR•DVD key. The illuminated ON•OFF key blinks four times and then turns off.

Your remote is now either in VCR or DVD Programming Mode, depending on which you chose. Proceed to step 5.

TV SAT•CBL

ON•OFF

(BLINK)

ON•OFF

ON•OFF

(BLINK)

5.Press and hold the component key (TV, VCR•DVD, SAT•CBL) you wish to program. The illuminated ON•OFF key turns on and remains on.

6.While holding the component key down, press and hold the ON•OFF key. The illuminated ON•OFF key turns off.

7.After holding both keys down for three seconds, the illuminated ON•OFF key turns back on.

8.Release both keys. The illuminated ON•OFF key remains on.

9.Refer to the Brand Codes in the enclosed Code Lists. Press and release the appropriate brand code key (Numbers 0-9), using the number keys on the keypad. The illuminated ON•OFF key blinks once.

ON•OFF

ON•OFF

(BLINK)

Throughout the programming of each key, be sure to keep the remote pointed at the IR sensor of the component you are currently programming the remote to control.

10.Press and release the ON•OFF key repeatedly until your component turns off. Each time you press the ON•OFF key, the illuminated ON•OFF key blinks, and the next code is sent. The Brand Code Search begins with the first code in the chosen brand list for that component and cycles through all the codes for that brand. If your component turns off, you have found the correct code. (If it cycles through and the illuminated ON•OFF key blinks four times and turns off, all codes in the chosen

5