TechniSat manual Safety Instructions, TechniSat VC 2002 S

Models: VC 2002 S

1 12
Download 12 pages 32.91 Kb
Page 2
Image 2
TechniSat® VC 2002 S

TechniSat® VC 2002 S

INSTRUCTION MANUAL FOR THE TECHNISAT VC 2002 S

.

SAFETY INSTRUCTIONS

In the interests of safety please read and observe the following instructions

before using your new VC 2002 S. This sheet and the following pages

concerning installation and operation should be retained for future reference.

INSTALLATION:

The procedures set out on page 5 should be fol- lowed carefully.

NOTE:

Always connect the LNB before connecting to the mains supply. Failure to do this may cause damage to the appliance.

Ventilation:

Vents on the top and side panels are provided for necessary ventilation. The appliance should not be placed in a position where the free pas- sage of air would be severely restricted. In addi- tion, for the same reasons as above, the VC 2002 S should not be placed on a soft base.

Water and moisture:

Ensure that the appliance does not come into contact with any dampness or moisture - RISK OF ELECTRIC SHOCK (and/or damage to the VC 2002 S).

Heat:

Do not install the VC 2002 S in the immediate proximity of a heat source (radiator, oven etc.).

CARE AND USE:

Power source:

Connect the VC 2002 S to a power supply which matches the requirements of the appliance (240 V/50 Hz).

Safe connection to the mains:

The mains leads should be routed so that they are not likely to be walked on or pinched by items placed against them.

When not in use:

If the VC 2002 S is left unattended or unused for long periods of time be sure to unplug the mains connector.

Unplug the VC 2002 S from the mains when:

-the mains lead or mains connector is damaged

-the VC 2002 S has been exposed to rain or water

-a solid object or liquid substance has entered the appliance via the air vents

-there is a noticeable change in the performance of the VC 2002 S, the appliance is not operating as normal

-the VC 2002 S has been dropped or the outer casing has been damaged

NOTE:

Servicing and repairs must only be carried out by trained service staff.

Accessories and replacement parts:

Both accessories and replacement parts should only be purchased as recommended by your satellite dealer. Be sure to consult your dealer in all aspects concerning equipment purchase, servicing and repairs.

Cleaning:

Disconnect the VC 2002 S from the mains befo- re cleaning. Use a damp cloth only. Do not use liquid or aerosol cleaners.

2

Page 2
Image 2
TechniSat manual Safety Instructions, TechniSat VC 2002 S