TE_ASPIRATEUR_COMPACTEO_ERGO_CYCLONIC_903086-01_903086 03/05/12 16:36 Page15

3.2 Microfilter (12)

Open the motor protection grid (11) - fig. 33a.

Separate the microfilter * (12) from the motor protection grid (11) - fig.33b.

Discard the microfilter* (12) into a dustbin - fig. 33c and replace it with a new microfilter (ref. RS-RT900037). Place the new microfilter * (12) on the motor protection grid (11) - fig.33d.

Place the pins of the protection grid (11) in the notches on the dust compartment housing (7) - fig. 33d. Lock the motor protection grid (11) - fig. 33e.

Make sure the microfilter* (12) and the protective grid (11) are properly in position before closing the lid (8).

Cleaning the vacuum cleaner

EN

Wipe the body of the vacuum cleaner and accessories with a soft damp cloth, then dry.

Wipe the lid with a dry cloth- fig. 34.

Do not use detergents or any corrosive or abrasive products.

6. TROUBLESHOOTING

Important: As soon as your vacuum cleaner stops performing efficiently, and before making any checks, stop it by pressing on the On/Off pedal.

If your vacuum cleaner does not start

The appliance is not powered: make sure the appliance is properly connected.

If your vacuum cleaner has no suction

An accessory or the hose (19) is blocked: unblock the accessory or the hose (19). Ensure that the dust compartment (13) is properly mounted and present.

The lid is not properly closed: check that the dust compartment (13) is properly in position and close the lid (8).

If your vacuum cleaner suction is not working properly or is making a whistling noise

An accessory or the hose is partially blocked: unblock the accessory or the hose (19).

The dust compartment is full: empty it (see CLEANING AND MAINTENANCE chapter).

The filtration system is saturated: clean the HEPA filter capsule (14) (see CLEANING AND MAINTENANCE chapter).

If the problem persists, change the filtration system (see the CLEANING AND MAINTENANCE chapter).

The electronic power regulator (3) is set at minimum: increase the power using the electronic power regulator (unless you are cleaning fragile fabrics).

The mechanical power regulator is open: close the mechanical power regulator on the power nozzle - fig. 9. Ensure that the dust compartment (13) is well properly positioned in the dust tray housing (7).

If the lid does not close

Ensure that the dust compartment (13) is well properly positioned in the dust tray housing (7).

If the suction attachment is difficult to move

Open the mechanical power regulator on the power nozzle or decrease power - fig. 9.

Ensure that the position (brush retracted / brush out) of the suction attachment (22) corresponds to the surface being cleaned.

If the power cord does not wind up completely

The cord slowed down as it was winding up: bring the cord back out and press the cord winder pedal (4) again.

If your vacuum cleaner stops while in operation

* According to model: these systems are specific to certain models or are accessories available as an option.

15