•Place the lid (C) on the juice collector (E) (outlet to the rear). (see Fig. 3)
•Position the 2 locking clips (H) on the lid (C). Make sure the 2 locking clips are properly clipped to the lid. (see Fig. 4)
•Place the pulp collector (G) at the back of the appliance by tilting it forward slightly and then sliding it under the lid (C). (see Fig. 5)
•If you want to separate the juice from the froth, insert the froth separator (M) in the juice jug (N). Place the lid (L) on the juice jug (N). (see Fig.6a)
•Place the stainless steel grid (P) on the drip tray (Q). Place this whole unit on the Motor unit in the appropriate slot.
•Place the juice jug (N) under the spout at the front of the appliance. (see Fig. 6b)
•Plug the juicer in. The cord storage (R) lets you adjust the length of the cord.
What speed to use?
|
| Approximate weight | Quantity of juice | |
Ingredients | Speed | obtained in cl (*) | ||
(kg) | 1 glass = 20 cl | |||
|
| |||
|
|
| (approximately) | |
Apples | 2 | 1 | 65 | |
Pears | 2 | 1 | 60 | |
Carrots | 2 | 1 | 60 | |
Cucumbers | 1 | 1 (about 2 cucumbers) | 65 | |
Pineapple | 2 | 1 | 60 | |
Grapes | 1 | 1 | 60 | |
Tomatoes | 1 | 1.5 | 65 | |
Celery | 2 | 1.5 | 60 | |
|
|
|
|
An inappropriate choice of speed can lead to the abnormal vibration of the unit.
(*)The quality and quantity of juice varies widely depending on the harvest date and variety of each vegetable or fruit. The quantities above are therefore approximate.
•Turn the unit on using the control button (I).
•Introduce the fruit or vegetables through the feeder tube (B).
Fruits and vegetables should be introduced with the motor running.
•Slide the pushrod (A) in the feeder tube (B) by aligning the groove with the small notch on the side.
Do not push down on the pushrod too hard. Do not use any other utensil. Do NOT push with your fingers.
•When you have finished, stop the appliance using the control button (I) and wait for the filter to stop completely (D).
•When the pulp collector (G) is full or when the juice start to flow more slowly, empty the pulp collector (G) and clean the filter (D).
8
