Panel Mounting | Teledyne 760 PLUS instruction

7.3. Mounting

Cut out panel as shown in the diagram below.

7.4.Panel Mounting

1)Slide power supply into panel from the top.

2)Attach brackets to the side of the power supply.

3)Tighten screws against panel.

Manual: 147-082010_HPM-760-Plus-Vacuum-Gauge

Page 16 of 16

Image 16

Teledyne 760 PLUS instruction manual Panel Mounting

Contents

Teledyne Hastings Manual Print History Table of Contents Features Power Supply/DisplayGeneral Information Piezo Vacuum Transducer 760s Specifications Output signal options Piezo Transducer 760s Installation InstallationReceiving Inspection Power Supply/Display Cables and Wiring Power Supply/Display InstallationPlus Interconnect Cable Operating Information General Piezo Transducer Input Power Piezo Transducer Output SignalPower Supply/Display Input Power THPS-760 Power Supply Physical Layout J3 Input/Output Connector Power Supply Relay Set Point AdjustmentGrounding Considerations Pressure Measurements Auxiliary Relay Contacts Hastings 760s Option-5 Transducer Zero and Span Adjustment Hastings 760 Plus Piezo Transducer Zero and Span AdjustmentCalibration Power Supply/Display Authorized Maintenance MaintenancePiezo Transducer Authorized Maintenance Warranty Repair Policy Non-Warranty Repair Policy Front Panel Diagrams and DrawingsRear Panel Mounting Panel Mounting