Teledyne 760 PLUS 2.3. Power Supply/Display Installation

Manual: 147-082010_HPM-760-Plus-Vacuum-Gauge Page 7 of 16

2.3. Power Supply/Display Installation

Cut a panel opening to the following dimensions; 3.62” (92mm) wide, 1.77” (45mm) tall. Insert the

power supply/display through the panel cutout and secure in place using mounting hardware supplied.

2.3.1. Power Supply/Display Cables and Wiring

Three cables provide all wire connections for the Hastings 760 Plus and are shown below:

760 Plus Interconnect Cable

To power supply/display To Piezo Transducer (760s)

Interconnect cable, 4-cond. # 20 A.W.G., 8-ft length standard

Power Supply/Display Power Cable

To power supply/display

AC power cable, 2-cond w/polarized plug., # 18 A.W.G., 8-ft length standard

Fig 2-1

Fig 2-2

Contents

Main Manual Print History Visit www.teledyne-hi.com for WEEE disposal guidance. Table of Contents 1. General Information 1.1. Features Piezo Vacuum Transducer (760s): Power Supply/Display: 1.2. Specifications 2. Installation 2.1. Receiving Inspection 2.2. Piezo Transducer (760s) Installation 2.3. Power Supply/Display Installation 2.3.1. Power Supply/Display Cables and Wiring 760 Plus Interconnect Cable Interconnect cable, 4-cond. # 20 A.W.G., 8-ft length standard Power Supply/Display Power Cable 3. Operating Information 3.2. Piezo Transducer Input Power 3.3. Piezo Transducer Output Signal 3.4. Power Supply/Display Input Power 3.5. THPS-760 Power Supply Physical Layout 3.5.2. Rear Panel Grounding Considerations 3.6. Power Supply Relay Set Point Adjustment Auxiliary Relay Contacts 3.7. Pressure Measurements 4. Calibration 4.1. Hastings 760 Plus Piezo Transducer Zero and Span Adjustment 4.2. Hastings 760s Option-5 Transducer Zero and Span Adjustment 5. Maintenance 5.1. Power Supply/Display Authorized Maintenance 5.2. Piezo Transducer Authorized Maintenance 6. WARRANTY 7. Diagrams and Drawings