Teledyne API T703 Calibrator Operation Manual Getting Started

41

Table 3-6: Possible Warning Messages at Start-Up

MESSAGE MEANING

ANALOG CAL WARNING The calibrator’s A/D converter or at least one analog
input channel has not been calibrated.
CONFIG INITIALIZED Stored Configuration information has been reset to the
factory settings or has been erased.
DATA INITIALIZED The calibrator’s data storage was erased.
LAMP DRIVER WARN The firmware is unable to communicate with either the
O3 generator or photometer lamp I2C driver chips.
O3 GEN LAMP TEMP WARNING The O3 generator lamp temperature is outside of
allowable limits.
O3 GEN REFERENCE WARNING The O3 generator’s reference detector has dropped
below the minimum allowable limit.
O3 PUMP WARNING The pump associated with the O3 photometer has failed
to turn on.
PHOTO LAMP TEMP WARNING The photometer lamp temperature is outside of
allowable limits.
PHOTO REFERENCE WARNING The photometer reference reading is outside of
allowable limits.
REAR BOARD NOT DET The calibrator’s motherboard was not detected during
power up.
RELAY BOARD WARN The firmware is unable to communicate with the
calibrator’s relay board.
SYSTEM RESET The calibrator has been turned off and on or the CPU
was reset.

07223B DCN6378