Manuals / Telex / Home Audio / Stereo System

Telex NEO-10 technical manual PIN Change, Set PIN Number

Models: NEO-10

1 26

Page 15

3.8 PIN Change

The PIN number is the password required to enter the setup mode of the NEO. The default is no PIN number. The PIN number is a 4 digit number that must be entered twice and then submitted.

Figure 9 - Set PIN Number

Page 15

Image 15

Telex NEO-10 technical manual PIN Change, Set PIN Number

Contents

November Technical ManualModel NEO-10 Version Table of Contents 1 Introduction 2.3 Relay/Input Ports 2 Connecting NEO to the World2.1 RS-232Port 2.2 Ethernet Port3 Software Configuration of NEO Enter “technobabble” for the factory password D = Current Subnet Mask, do you want to change? F = Do you want to reset any of the above?7 A B C D E F C = Current IP address, do you want to change?3.3.2Unit IP Address 3.2 General Setup via Web Pages3.3 Basic Ethernet Setup Screen 3.3.1Use DHCP ServerFigure 3 - Basic Ethernet Setup Screen 3.4 Multicast Setup 3.5 Debounce Input Settings 3.6 Echo Packet Figure 7 - Echo Packet Setup Figure 8 - Clone from Other NEO 3.7 Clone From Other NEOFigure 9 - Set PIN Number 3.8 PIN ChangeFigure 10 - Save to EEPROM 3.9 Save Changes to EEPROM4 BILL OF MATERIAL AND SCHEMATICS 879796 PCB ASSY, NEO-10Telex Communications INC 879796 PCB ASSY, NEO-10Telex Communications INC 879796 PCB ASSY, NEO-10Telex Communications INC TYPE 879796PCB ASSY, NEO-10 Telex Communications INCPage Page Page Page TELEX Communications, Inc 5 Warranty, Service, Repair, and Comments