TR-16 SYNTHESIZED

RECEIVER

Keep a clear, unobstructed path between the trans- mitter and receiver antennas for a clear transmis- sion.

1 2

3

E.D.R.

4

1.Channel Display 1-9 through A-H and low battery indicator

2.Lock Indicator (see Change Lock Out)

3.High Frequency Emphasis Indicator (on when symbol is showing)

4.Enhanced Dynamic Range Indicator.

Figure 8

TR-16 Display

Channel Selection

1)Turn the receiver on. A channel letter will show in the display.

2)Press the SET button once and the Channel indi- cator will flash.

3)Press the button and the Channel will scroll up, match the channel to the transmitter channel being used (TT-16, TT-44).

4)Press SET, the channel indicator will stop flash- ing and the channel is set.

Enhanced Dynamic Range (E.D.R.) Operation

1)To engage the E.D.R function turn the TR-16 off with the volume control thumb wheel.

2)Press and hold the SET button while you turn the TR-16 back on. The E.D.R. symbol will be dis- played in the lower right corner to indicate the mode is active.

3)Repeat the procedure to disable the E.D.R. func- tion.

Lock Out

The TR-16 SET button can be locked to prevent E.D.R. activation, and unintended channel changes. The High Frequency Emphasis button will remain active at all times for the convenience of the user.

1)To engage the Lock Out Feature, press the SET and buttons at the same time and hold them down for 5 seconds.

2)The padlock symbol will appear and the set but- ton is disabled.

3)To unlock the system, press the SET and but- tons and hold them for 5 seconds or until the padlock symbol disappears.

SET

SWITCH

BUTTON

HEADPHONE JACK

TREBLE CONTROL

SET

 

 

E.D.R.

 

VOLUME OFF/ON CONTROL

The Telex TT-16 transmitter is equipped with E.D.R., Enhanced Dynamic Range (companded) au- dio. This mode greatly improves the Audio Signal to Noise Ratio when used with the Telex Model TR-16 receiver. The E.D.R. mode must be selected on both the transmitter and receiver to be effective. If using the TR-16 with a TT-44 IFB Transmitter, E.D.R. must be turned off.

-9-

Page 10
Image 10
Telex TT-16 manual TR-16 Display Channel Selection