Telex ur-700 operating instructions Receiver Set-up, Antenna Mounting

Receiver Set-up

Connect the supplied AC power adapter to an AC outlet supplying 105 to 125 volts AC, 60 Hz. The 230 volt export model should connect to an AC outlet supplying 210-240 VAC, 50-60 Hz.

Connect the UR-700 to your equipment:

Insert the appropriate audio connector and cable into the mic or line receptacle on the rear of the UR-700.

Insert the other end of the audio cable into the input of your Mixer/Amplifier.

If utilizing the two 1/4 wave antennas supplied, connect both of them to the back of the receiver at a 90angle as shown in Figure 3. Tighten the connectors securely. (If using other types of antennas, refer to the placement instructions on page 14 of this manual.)

Figure 3

Antenna Mounting

-8-