Telular SX5T CDMA Call Restrict SX5T-500C only, Dial Tone After Remote Disconnect Dtard

Call Restrict (SX5T-500C only)

Call Restrict allows you to determine which calls may or may not be placed through your SX5T. When the Call Restrict level is set to Use Table, the Call Restrict feature checks outgoing calls against user-defined permit and deny tables to determine whether to permit or deny the outgoing call. Each table (permit and deny) may contain up to ten entries.

To set the Call Restrict level:

• From Configuration Mode, press #		*	1	4	5	* <1, 2, 3, or 4> # ,
where <1, 2, 3, or 4> are as follows:
1	= No Restriction (default setting)
2	= Use Table
3	= Emergency Only (only emergency calls permitted; all other calls denied)
4	= Clear Table

To set the Call Restrict table entries:

• From Configuration Mode, press	#	*	1	4	6	* <0 or 1> *
<index> * <number> #	, where the options are as follows:

<0 or 1> = Table mode (0 = Deny table; 1 = Permit table) <index> = Table entry

<number> = 10-digit phone number for the Call Restrict entry

(For example, if you wanted to add 555-123-4567 as the third entry in your Deny table, you

would press		#	*	1	4	6	*	0	*	3	*	5	5	5
1	2	3	4	5	6	7	#	)

Dial Tone After Remote Disconnect (DTARD)

To allow you to place another call when a connection has been terminated remotely (when the other party has hung up the phone), you may elect to have the SX5T return to dial tone automatically. If you elect not to enable DTARD, you will need to hang up the phone before placing another call.

To enable Dial Tone After Remote Disconnect (to return to dial tone):

• From Configuration Mode, press # * 8 * 1 # .

To disable Dial Tone After Remote Disconnect:

• From Configuration Mode, press # * 8 * 0 # .

Note:

If Dial Tone After Remote Disconnect is disabled, additional remote disconnect options may be available. See “Disconnect Tone” on page 33 for more information.

Phonecell® SX5T CDMA2000 14 User Manual