Test Summary, Chapter, Page, Topic | Texas Instruments bq24010/2

Test Summary

Chapter 2

Test Summary

This chapter shows the test setups used and the tests performed in evaluating the EVM.

Setup: The bq24010/2 EVM board requires a 5-VDC, 1-A power source to provide input power and a single-cell Li-Ion or Li-Pol battery pack. The test set- up connections and jumper setting selections are configured for a stand-alone evaluation but can be changed to interface with external hardware, such as a microcontroller.

Topic		Page

2.1	I/O and Jumper Connecations	. . 2-2
2.2	Test Procedure	. . 2-2

Test Summary

2-1

Image 9

Texas Instruments bq24010/2 manual Test Summary, Chapter, Page, Topic

Contents

PMP Portable Power SLUU125AUser’s Guide January IMPORTANT NOTICE EVM IMPORTANT NOTICE EVM WARNINGS AND RESTRICTIONS 3 Schematic, Physical Layouts, and Bill of Materials ContentsFigures Tables Contents Chapter IntroductionPage Topic 1.2 Performance Specification Summary Table 1-1. Performance Specification Summary1.1 Background Test Summary Test Summary 2.1 I/O and Jumper Connections 2.2 Test Procedure In place of a battery, a source meter that can sink current can easily be adjusted to test each mode 2.2.3 Procedure 2.2.2 Equipment Setup2.2.1 Equipment Figure 2-1. Load Test Board 4 Verify that output voltage BAT+ settles between 3.2 V and 3.95 Schematic Schematic, Physical Layouts, and Bill of MaterialsSchematic, Physical Layouts, and Bill of Materials Physical Layouts 1 µ F 3.1 Schematic 3.2 Physical Layouts Figure 3-2. Assembly View3.2.1 Board Layout Physical Layouts Figure 3-3. Top Layer Figure 3-4. Bottom Layer 3.4 Reference 3.3 Bill of MaterialsTable 3-1. Bill of Materials Bill of Materials