Batteries
Battery type
CBR 2™ motion detector is designed to operate with 4 AA alkaline batteries. CBR 2™ motion detector can run without batteries only if attached to a CBL 2™.
Battery installation
Exit the EasyData application or RANGER program before changing batteries.
1.Holding the CBR 2™ motion detector upside down, use your thumb to slide the battery compartment cover toward the back of the CBR 2™ motion detector.
2.Position batteries according to the diagram on the inside of the CBR 2™ motion detector battery compartment.
3. Two batteries fit positive side up in the side marked +. Two batteries fit negative side up in the side marked
4.Slide the cover back on. CBR 2™ motion detector is ready to begin sampling.
CBR 2™ sonic motion detector low battery warnings
The CBR 2™ motion detector has two mechanisms to alert you that the batteries are low:
0The EasyData App displays a warning message on calculator screen while trying to collect data.
0The red light flashes intermittently while the CBR 2™ motion detector is collecting sample data.
You can check battery status using the RANGER program. From the Main Menu, select 5:Tools, then select 3:CBR Status. The battery status is checked and displayed on the first line of the screen.
Battery precautions
0
0
0
0
0
0
0
DO NOT use rechargeable batteries.
Replace all four batteries at the same time. Do not mix brands of batteries. Do not mix types within a battery brand.
Install batteries according to the diagrams inside the battery compartment.
Properly dispose of used batteries immediately. Do not leave them within the reach of children.
Do not heat, burn, or puncture batteries. Batteries contain hazardous chemicals and may explode or leak.
Do not mix rechargeable and nonrechargeable batteries.
Do not place nonrechargeable batteries in a battery recharger.
40 GETTING STARTED WITH THE CBR 2™ SONIC MOTION DETECTOR | © 1997, 2004, 2006 TEXAS INSTRUMENTS INCORPORATED |
