Chapter 2
Quick Start
The steps in this chapter can be followed to quickly prepare the TPA102 MSOP audio amplifier EVM for use. Using the TPA102 MSOP EVM with the TI plug-n-play audio amplifier evaluation platform is a quick and easy way to connect power, signal and control inputs, and signal outputs to the EVM using standard connectors. However, the audio amplifier evaluation module can be used stand-alone by making connections directly to the module pins, and can be wired directly into existing circuits or equipment.
The platform switch and jumper settings shown in Table 2–1 are typical for the TPA102 MSOP EVM and will cause the TPA102 IC to shutdown/mute when a plug is removed from platform headphone jack J10.
Table 2–1. Typical TI Plug-N-Play Platform Jumper and Switch Settings for the TPA102 MSOP EVM
EVM | JP6 | JP7 | JP8 | S2 | S3 |
| | | | | |
TPA102 | X | Lo | X | Note 2 | U5 |
Notes: 1) X = Don’t care
2)Set S2 to ON when signal conditioning board is installed in U1; set S2 to OFF when no signal conditioning board is installed.
Topic | | Page |
| | |
2.1 | Precautions | . . 2–2 |
2.2 | Quick Start List for Platform | . . 2–3 |
2.3 | Quick Start List for Stand-Alone | . . 2–4 |
| | |
2-1
