Texas Instruments manual 2. TUSB3210 Evaluation Board, Running Title-Attribute Reference

Models: TUSB3210

1 22

Page 11

Running Title—Attribute Reference

TUSB3210 device. A USB cable should be plugged into a USB port on a PC or into a USB hub and connected to the TUSB3210 EVM type-B connector (U3).

1-3

Image 11

Contents

MSP USB User’s GuideTUSB3210 Generic Evaluation Board 2005Applications IMPORTANT NOTICEProducts EVM IMPORTANT NOTICE EVM WARNINGS AND RESTRICTIONS Related Documentation From Texas Instruments How to Use This ManualRead This First About This ManualFCC Warning Trademarks2 EVM Operation ContentsFigures TablesPage Topic Hardware and Software RequiredChapter PageFigure 1−1. TUSB3210 Evaluation Equipment 1.1 Equipment1.2 Hardware Overview Chapter Title-Attribute Reference Figure 1−2. TUSB3210 Evaluation BoardFigure 1−3. TUSB3210 EVM Connected to a Compact Flash Daughterboard Running Title-Attribute ReferenceRunning Title-Attribute Reference Figure 1−4. TUSB3210 Printed-Circuit Board REV 1.1-Top SideChapter Title-Attribute Reference Figure 1−5. TUSB3210 Printed-Circuit Board REV 1.2-Top SideRunning Title-Attribute Reference Reference Bill of MaterialsRunning Title-Attribute Reference QuantityChapter Title-Attribute Reference 1.4 Schematic DiagramRunning Title-Attribute Reference Page Topic EVM OperationChapter Page2.4 Light Emitting Diodes LEDs 2.1 TUSB3210 Setup2.3 Power Supplies 2.2 Interfaces and USB Port2.6 EEPROM 2.5 Jumpers and Switches2.7 GPIO Connector Table 2−2. Jumpers and SwitchesRunning Title-Attribute Reference Figure 2−1. GPIO ConnectorPage If S2 or S3 tied to ground powerWait 10ms before enable MMBT4401