Thermador SC272 Electrical connection, Electrical Installation, Grounding, Thermador Cooktops

		Table 1
	Under-The-Counter Installation with
	Thermador Cooktops
Model	Type of Cooktop		Model	Type of Cooktop
Number			Number
CER30			CGX304
CE304	Glass Ceramic top - electric		CGX365	Glass Ceramic top - gas
CE365			CGX456
CE456
			SGC304R
*TMH30			SGC365R
			SGC456R	Steel top - gas
*TMH36G	Steel top - electric coil
			SGCS304R
*TMH45P
			SGCS365R
GGS30	Glass top - gas		SGCS456R
			SGS36G
GGS365
			CD365	Glass Ceramic top - gas and electric
			CD456
* See Figure 4

STEP 3: ELECTRICAL INSTALLATION

All model ovens on the front cover are dual rated, designed to be connected to either 120/240V AC or 120/ 208V AC, 60 Hz, 4 wire, single-phase power supply.

The S301 and SC301 require a 20-amp circuit. The C271, C301, CM301 SMW272 and SM272 require a 30-amp circuit. The S272, SC272, SCD272, C272, S302, SC302, SCD302 and C302 require a 40-amp circuit. The CM302 and CJ302 require a 50-amp circuit.

The electrical supply should be a 4-wire single-phase AC. Install a suitable conduit box (not furnished) as shown in Figures 2 or 3.

Electrical connection:

1.Connect the red oven wire to the red electrical supply wire (hot wire).

2.Connect the black oven wire to the black electrical supply wire (hot wire).

3.Connect the white neutral oven wire to the white neutral (not bare ground) electrical supply wire.

4.Connect the bare ground oven wire to the bare ground electrical supply wire.

The conduit cable, where connected at the oven, swiv- els. Rotate conduit cable upward (or downward) and direct through hole prepared in cabinet to attach to J- Box.

To facilitate service, the flex conduit must not be shortened and should be routed to permit temporary removal of the oven.

Fig. 4- TMH Models Installation Minimum Wall Clearance

B	Combustible Wall
	Countertop
	Cutout

A		A
Cooktop	Minimum Distance to Combustible Wall
Model	A (cm)	B (cm)
TMH30	3" (7, 6 cm)	2" (5, 1 cm)
TMH36G	2-7/8" (7, 3 cm)	2-3/4" (7, 0 cm)
TMH45P	3-3/4" (9, 5 cm)	2" (5, 1 cm)

GROUNDING

IMPORTANT: Local Codes might vary, installation, electrical connections and grounding must comply with all applicable local codes.

1.If local codes permit grounding through the electrical supply neutral, connect both the white neutral wire to the bare ground wire from the oven to the white neutral electrical supply wire.

2.If local code requires a separate ground, connect the white oven neutral wire to the white neutral electrical supply wire and the bare ground oven wire to the bare ground electrical supply wire.

Page 6