STEP 5: INSTALLING THE BOTTOM TRIM
Install the bottom vent trim and se- cure with (2) screws provided, one at each top end corner of the trim. The sheet metal bottom of the oven should be under the trim, except for the section at the center. To install the screws, open the door. The holes are visible at each end below the left and right hinges. Place and tighten screws. See Fig. 6 View 'A'.
| View 'A' |
Side | Fig. 6 - Installing |
View | Bottom Trim |
'A' |
|
Thermador reserves the right to change specifications or design without notice. Some models are certified for use in Canada. Thermador is not responsible for products which are transported from the United States for use in Canada. Check with your local Canadian distributor or dealer. Thermador, 5551 McFadden Avenue, Huntington Beach, CA 92649.
For the most up to date critical installation dimensions by fax, use your fax handset and call
5551 McFadden Avenue, Huntington Beach, CA 92649 •
ECO12582 •
