208V ELECTRICAL HOOKUP
Applies to C271, C272, C301, C302, CM302 and CJ302 models only.
Your oven has been preset to be hooked up to 240V.
1.Turn off the oven(s).
2.Open the upper oven door.
3.Press and hold the UPPER OFF pad in a double oven or the OFF pad in a single oven.
4.While the UPPER OFF pad or the OFF pad is held down, press the CLEAN pad .
5.240 will appear in the temperature digits. Release all pads.
6.Touch CLEAN and 208 replaces 240 in the tempera- ture digits. This will toggle with touches of the Clean pad.
7.To complete the change, touch UPPER OFF or OFF.
Note: When power is first supplied to the unit (and the door is unlocked), the CLOCK will flash. Set Time of Day as described in the Care and Use Manual. If the door is locked, the LOCK symbol will light for a few seconds while door is automatically unlocking and CLOCK will flash.
Fig. 5 -
Removing
the Door
Note: Removing the door for installation reduces the weight of the oven by 30 lbs. (14 kg) per door.
➞
Collar
➞
To Unlatch
and Close
Door
Position of
Hinge Latch
to remove door
Hinge Arm
STEP 4: INSTALLING THE OVEN
CAUTION: DO NOT MOVE OR LIFT OVEN BY DOOR HANDLE. DOOR GLASS BREAKAGE MAY OCCUR.
CAUTION: THE DOOR OF THE CM301 AND THE UPPER DOOR OF THE CJ302 AND CM302 ARE NOT REMOVABLE.
For ease of installation, some oven door(s) may be re- moved to reduce the weight of the oven by 30 pounds per door. To remove the door, open the door and hold it all the way open. Close the hinge latches See Fig. 5. The door can now be removed by gently lifting and pulling the door, (including the hinges) up and out of the frame.
IMPORTANT: Reinstall the door very carefully. Be certain that the hinge arm does not hit the porcelain collar around the clearance slot or it will chip the porcelain.
After installing the unit, replace the door(s), be certain both hinge arms are well inserted and secure, and that the hinge latch is fully released.
Anchor flexible metallic conduit to conduit box with suitable box connector. Connect power supply leads to oven conduit supply leads, being sure that neutral wire is connected to white wire.
Remove the bottom trim from the top of the unit. Remove the base skid. See Fig. 1. Slide the oven into the opening being careful not to scratch side trims. Secure oven with the screws supplied through the side of the front frame into the cabinet.
Note: To secure the oven to the cabinet, use the 4 screws provided (2 each side).
Page 7
