CAUTION
Clean burner prior to use after storing, at the beginning of grilling season or after a period of one month not being used. Spiders and insects like to build nests in burner tubes (especially during colder months). These nests can cause fires in burner tubes or under grill.
Typical spider webs inside burner.
Cleaning the Burner Assembly.
1.Turn gas off at control knob and LP tank.
2.Remove cooking surface.
3.Remove regulator/valve from grill.
4.Clean outside of burner with soap and water. Open clogged holes with a thin wire.
Examine holes. Due to normal wear and corrosion some holes may become enlarged. If any large cracks or holes are found, replace burner. Burner can be cleaned either installed or removed.
5.If grill is to be stored, coat burner lightly with cooking oil. Wrap in protective cover to keep insects out.
6.Replace cooking surface.
VERY IMPORTANT: Before cooking again on grill, follow Burner Flame Check and warnings on pages 2 and 19.
•Use only plastic tools.
•Do not cut food on surface.
•Do not put pots or pans on surface.
•Do not leave lid down for more than 10 minutes without food on the grill.
Storing Your Grill
•Clean cooking surface and grease container.
•When LP tank is connected to grill, store outdoors in
•Cover grill if stored outdoors.
•Store grill indoors ONLY if LP tank is turned off and disconnected, removed from grill and stored outdoors in
•Leak test the grill after removing from storage and follow Cleaning Burner Assembly instructions before starting grill.
