MECHANICAL INSTALLATION 110SR
NEW / EXISTING CONSTRUCTION INSTALLATION PROCEDURES:
Before you begin:
Please read and understand all of these instructions thoroughly before beginning any work.
Note that construction work for the installation of all Tannoy products must be done to local building codes by qualified, licensed installers. A local building inspector should approve any overhead installations. Always use safety goggles when cutting material using a RotoZip™. Tannoy assumes no liability for cause and effect of improper installation work.
Your package includes:
•110SR subwoofer system
•11 piece supplied screw package
•
•Individually packaged grille
Parts / tools required:
The following is a list of suggested materials and tools. Your needs may differ slightly at each site.
•Rotozip™ cutout tool and Guidepoint™ bit.
•2ea. 1/2” #8 wood screws
•Cordless screw gun
•Combination square and /or tape measure
•Additional 2” x 4” lumber, in 24” pieces
•Trim saw (optional)
Site preparation and installation procedures:
Please note that the 110SR is designed for installation in a ceiling with exposed ceiling joists. The
Please refer to the photographs as a guideline for installing the
1)(Fig. 1) Measure the locations for two 24” strips of 2” x 2” or 2” x 4” blocking. These must be used in order for secure mounting to the
2)(Fig. 2) Screw the blocking to the joist with several evenly spaced screws. (Fig. 3) Fasten the
3)(Fig. 4) Shows the
4)After the
5)Also at this time, we recommend that you install a safety line typically a light gauge wire rope, from a secure point on the support structure above the subwoofer. Attach this to the strapping on either side of the sub and suspend it in case the installation is compromised. Follow the instructions for wire rope installation from you wire rope supplier and check with your local building codes for specifics.