TOA Electronics F-1000W, F-1000B Wall and pole 0º horizontal to 45º downward, Terminal Cover Use

7.NOTES ON OUTDOOR INSTALLATION (F-1000BTWP and F-1000WTWP only)

•Be sure to mount the speaker in a vertical (portrait-style) orientation.

•Adjust the speaker's tilt angle within the shaded range shown below:

[Wall and pole: 0º horizontal to 45º downward] [Under eaves: 15º downward to 45º downward]

Note

Mount the speaker so that its rear-mounted terminal cover is positioned on the upper side.

Note

The speaker faces 15° downward when mounting to a horizontal surface.

0º

(horizontal)

45°

15°

0°

(horizontal)

(30°)

45°

•Install the speaker in locations exposed to an ambient temperature range of –10ºC to +50ºC. Exceeding this range could cause speaker failure.

•Use the supplied terminal cover when connecting the speaker cable.

[Terminal Cover Use]

3	2
	Terminal cover (accessory)
	Tapping screw 4 x 12 (accessory)

4 Bushing*

1

Speaker cable

Input terminal

[Stripped conductor]

10 mm

30 mm

Speaker unit

* Screwed onto the Terminal cover at the factory.

Notes

•For the speaker cable, use a cable with a diameter of 6 – 10 mm, which will fit the cable bushing.

•To ensure waterproof capabilities, firmly mount the terminal cover to the speaker and tighten the bushing on the cover.

Step 1. Feed the speaker cable through the bushing and terminal cover, then connect the cable to the input terminal.

Step 2. Attach the terminal cover to the speaker.

Attach the cover while pulling the cable so that it is not entangled inside the terminal cover.

Step 3. Hold the terminal cover tightly to the speaker using the supplied screws.

Step 4. Tighten the bushing.

Note

After tightening the bushing by hand, use a tool to further tighten it another 90º (1/4-turn) or so. Note that parts can be damaged by over-tightening.

6