ASSEMBLY GUIDE
1. Insert Filter Assembly
Insert Filter Assembly into Dust Tank with Cyclone Cup pointing forward. Smaller cylinder above Cyclone Cup fits into back of Intake Hole. Gently press Filter Assembly forward until it fits snugly and securely inside Dust Tank (FIGURE 1).
NOTE: For more information on inserting individual filters, see Inserting Filters section on page 8 of this manual.
2. Connect Dust Tank
Insert large tab on
3. Connect Hose
Insert Hose into Intake Hole on top of Dust Tank. To accomplish this, press the two buttons on sides of hose end inward (FIGURE 3). Then insert Hose into Intake Hole until it clicks into correct position and stays securely in place (FIGURE 4). To remove Hose, repeat process and reverse by pulling Hose out from Intake Hole.
4. Deploy Power Cord
Grasp plug of power cord firmly and pull out from compartment on back of unit to desired length (15 ft. maximum) (FIGURE 5). To retract power cord back into storage compartment, unplug it from wall outlet and press Cord Retraction Button on top of unit. Hold button down until cord is completely retracted (FIGURE 6).
WARNING: Extend power cord ONLY to yellow mark on cord, as this indicates maximum safe length. DO NOT extend cord to red warning mark.
FIGURE 1 | FIGURE 2 | FIGURE 3 |
FIGURE 4 | FIGURE 5 | FIGURE 6 |
6 | Top Innovations, Inc. |