INSERTING/REMOVING FILTERS
Your ThunderVac utilizes three filters that work together to prevent dust and other particles from escaping the vacuum and
1.ULTRA Filter – traps over 92.4% of air impurities. Located inside Cyclone Cup
2.Charcoal Filter – reduces odors during cleaning process. Located behind Filter Assembly.
3.Exhaust Filter – located in rear compartment of unit.
INSERTING FILTERS
1.Place ULTRA Filter inside Cyclone Cup. Slide over the end of smaller cylinder inside Cyclone Cup (FIGURE 1).
2.Place Charcoal Filter inside Filter Disc, with softer side facing out. Filter Disc then fits into the back of
Filter Assembly, with exposed side of | FIGURE 1 |
filter placed against Filter Assembly |
|
(FIGURE 2). |
|
3.Open Exhaust Filter Access Door on back of main unit by pressing down on top tab and pulling outwards. Place filter into rectangular hole inside compartment (with grated side of filter facing out). Reattach Access Door
(FIGURE 3). | FIGURE 2 |
REMOVING FILTERS |
|
To remove filters, simply reverse steps |
|
listed above. This is useful for |
|
cleaning filters or replacing them with |
|
new ones. See Cleaning Filters |
|
section on page 9 for more |
|
information. DO NOT place a |
|
recently cleaned filter back into the |
|
unit until it is completely dry. | FIGURE 3 |
8 | Top Innovations, Inc. |