ASSEMBLING THE STEAM VACUUM
CONNECTING OTHER ATTACHMENTS
INSERTS
1.Slide two locks on top of Vacuum Head to “Open” position (FIGURE
2.Select desired insert, and place it into Vacuum Head as shown (FIGURE
3.While continuing to press insert firmly into Vacuum Head, slide both locks to “Close” position to lock insert securely into place.
AB
FIGURE 3
NYLON UTILITY BRUSH
1.Slide Nylon Utility Brush onto Steam Jet Nozzle as shown (FIGURE 4). Firmly press it on until it fits securely in place.
FIGURE 4
EXTENSION WANDS
1.Slide Open/Close lock on Extension Wand to “Open” position. Align Extension Wand with Vacuum/Steam Nozzles, and firmly press it on. Slide Open/Close lock to “Close” position.
2.Repeat Step 1 for second Extension Wand, connecting it to the end of first Extension Wand.
3.Select desired attachment (Squeegee Head, Steam Jet Nozzle, Vacuum Head or Small Vacuum Head), and connect it to end of second Extension Wand in the same way as you would connect it to Vacuum/Steam Nozzles (refer to Connecting Attachments to Vacuum/Steam Nozzles section on page 7 of this manual).
FIGURE 5
8 | Top Innovations, Inc. |
USING THE STEAM VACUUM
FILLING WATER RESERVOIR WITH WATER
1.Place Steam Vacuum on a flat, level surface.
2.Make sure Main Control Switch is set to “Off” (0) position and power cord is unplugged from electrical outlet.
3.Press and hold Steam Trigger to ensure that any remaining steam has been emitted from unit.
4.If unit has been in use, allow at least 30 minutes for boiler to cool.
5.Cautiously unscrew and remove Water Reservoir Cap.
6.Water reservoir should always be emptied after each use. If it was not emptied after the last use, empty it now. This will prevent
7.Fill Measuring Cup to maximum fill line (10 oz.) with water.
NOTE: To prolong the lifetime of your Steam Vacuum, we recommend using distilled or
8.Carefully pour water from Measuring Cup into water reservoir through fill hole, using Water Funnel to prevent spilling water.
WARNING: Extreme caution should be used when pouring water into the water reservoir. Do not look directly down into fill hole when filling. Keep your free hand and any children or pets at a safe distance.
9.Repeat steps 7 & 8 in order to have 20 oz. of water in water reservoir.
10.Replace Water Reservoir Cap, ensuring that it is screwed on tightly to prevent hot steam from escaping and causing injury.
FILLING WATER FILTRATION CHAMBER WITH WATER
1.Place Steam Vacuum on a flat, level surface.
2.Make sure Main Control Switch is set to “Off” (0) position and power cord is unplugged from electrical outlet.
3.Unhook two locks that hold Water Filtration Chamber cover (FIGURE 6), and remove cover.
4.Fill Measuring Cup to maximum fill line (10 oz.) with water.
5.Carefully pour water from Measuring Cup into Water Filtration Chamber. It does not matter which side of the chamber water is poured into.
6.Replace Water Filtration Chamber cover, and
FIGURE 6
Top Innovations, Inc. | 9 |
