USING THE STEAM VACUUM
OPERATING STEAM VACUUM
NOTE: Be sure that water reservoir and Water Filtration Chamber have already been filled and that all desired accessories are connected before following these steps.
1.Plug power cord into a convenient electrical outlet (make sure to first remove plastic cover that protects plugs during shipping).
CAUTION: This unit uses a grounded
2.Set Main Control Switch to desired mode (vacuum mode or steam mode) (FIGURE 7).
FIGURE 7
VACUUM MODE
1.When set to vacuum mode, unit suction will begin automatically. You are immediately ready to begin your vacuuming tasks.
2.While vacuuming, it is possible to alter the force of suction, by using switch on top of Handle. Move it forward to increase suction power, and move it backwards to decrease suction power. This is useful for when vacuuming rugs or other materials on which you may not want to use maximum.
3.As you vacuum, it may become necessary to stop and empty Water Filtration Chamber. Simply follow these steps:
-Unhook locks and remove Water Filtration Chamber cover,
-Remove Water Filtration Chamber (there are no locks holding it in place; simply pull it out),
-Remove filter
-Empty Water Filtration Chamber into toilet (for dirty water) or trash can
-Replace filter and refill Water Filtration Chamber with water (10 oz.)
-Set Water Filtration Chamber back in place
-Replace Water Filtration Chamber cover and
NOTE: It is recommended that you remove and clean filter in Water Filtration Chamber after several uses. Simply remove it and rinse thoroughly with warm water, then replace it. After approximately 6 months of regular use, you may wish to replace this filter to maintain optimum filtration. Refer to page 14 of this manual for information on obtaining replacement filters.
10 | Top Innovations, Inc. |
ASSEMBLING THE STEAM VACUUM
CONNECTING / DISCONNECTING HOSE
1.Align connector end of Hose with Hose Connection Base as shown (FIGURE 1), and insert it. Press in until two locking tabs on Hose snap through two holes on sides of Hose Connection Base.
2.To remove Hose from Hose Connection Base, press in on two locking tabs and firmly pull Hose out of Hose Connection Base.
FIGURE 1
CONNECTING ATTACHMENTS TO
VACUUM / STEAM NOZZLES
1.Slide Open/Close lock on Squeegee Head, Steam Jet Nozzle or Vacuum Head to “Open” position.
2.Align Squeegee Head, Steam Jet Nozzle, Vacuum Head or Small Vacuum Head with Vacuum/Steam Nozzles as shown (FIGURE 2), and press firmly onto Vacuum/Steam Nozzles. Note that Small Vacuum Head only fits onto Vacuum Nozzle, and does not have an Open/Close lock.
3.Slide Open/Close lock on Squeegee Head, Steam Jet Nozzle or Vacuum Head to “Close” position.
FIGURE 2
Top Innovations, Inc. | 7 |
