LEARNING ABOUT YOUR STEAMER
Please refer to the picture for each point
(1)The control HANDLE on the end of the hose sits just before the nozzle. The HANDLE is designed to be
heat free and is safe to grasp. Use the HANDLE to | 1 |
| |
aim the direction of the steam released from the |
|
nozzle. |
|
(2) The NOZZLE on the end of the handle is located on |
|
the end of the steamer hose. Always sit the NOZZLE |
|
end of the hose on the hanger rod when not in use. |
|
Keep the NOZZLE pointed upward and steam will |
|
rise. If you point the NOZZLE downward, water |
|
may condense and drip. |
|
(3) The ROD is designed to conveniently hang the hose |
|
handle and also can support garments for steaming. |
|
(4) The HOSE extends from the base of the unit. Do not |
|
pull on the HOSE with extreme pressure or you may |
|
c a u s e d a m a g e and leakage of s t e a m . |
|
(5) The ON/OFF switch is located on the front of the base. |
|
(6) The WATER CONTAINER is filled through a hole in |
|
the bottom and should be placed in the reservoir on the |
|
base. Avoid spilling excess water into the reservoir as |
|
this could cause the steamer to expel water from the |
|
nozzle. Do not try to substitute another water container |
|
for the one designed for this u n i t . |
|
(7)The WATER LEVEL can be seen visually in the water |
|
container. Do not operate the steamer without water |
|
in the WATER CONTAINER. |
|
(8) The steamer BASE houses the reservoir and water |
|
container. It also supports the hanger rod and hose. |
|
(9)The CASTERS allow the unit to roll freely. |
|
(10)The ELECTRICAL CORD plugs into a standard three- prong plug. Use only three prong UL approved extension cords with a minimum
(11)The DRAIN PLUG is located on the side for convenient drainage of the water reservoir .
( 12) The dual hook hanger allows for convenient simultaneous hanging of the nozzle and clothing.
P.4