Reassembling The Water Tank Valve Cap
If the plunger becomes separated from the Valve Cap, follow the following procedure.
A.Grab the Value Cap Assembly and rotate it counter clockwise about 1/8th of a turn. Lift straight up to remove the cap.
B.The disk will most likely be found inside the water container. Carefully drain the water from the container and search for the disk.
C.Insure the spring is around the plunger.
D.Place the small end of the plunger through the center hole of the cap.
E.Push the plunger through the central hole in the disk until it pops into place.
Note: Be sure the disc is oriented as seen in the bottom illustration.
F.Replace the Value Cap Assembly by aligning the notches and rotating the cap 1/8 turn clockwise.
G. Fill the tank with water and check the operation of |
|
valve by holding the tank by the handle and checking | I |
for leaks. |
|
Disk
\
valve
