Topcom 7000 manual do utilizador Charging batteries, Desktop charger, Plug in charger

OFF ON

Topcom Twintalker 7000

before you can reply to the message. At the end of each transmission the unit will send a beep. To reply, just press the PTT -button and speak into the microphone.

If 2 or more users press the PTT - button at the same time the receiver will receive only the stongest signal and the other signal

(s) will be supressed. Therefore you should only transmit a signal (press PTT - button) when the channel is free.

8Charging batteries

For safety reasons, only use the power adapter plug supplied (KEAD-237 (DVE DV-6400UP) for two units charging / KEAD-244 (DVE DV-6200UP) for one unit charging only).

Your radio will not Transmit / Receive during charging.

Set the main switch (6), located on the bottom of the walkie-talkies to ON.

8.1Desktop charger

The TT7000 is internally equipped with a build in Li-ion battery (3.7 V Li-ion Battery, 700 mAh). The high quality battery has a minimum of 300 charging cycles (empty to fully charged). The battery can only be replaced by a Topcom service center. The replacement of the battery is excluded from the warranty.

1.Put the desktop charger on a flat surface.

2. Plug one end of the supplied adapter into the electric socket and the other two ends into the connectors on the backside of the desktop charger

as illustrated in the diagram. 3. Set the main switch (6), located on the bottom of

the walkie-talkies to ON. 4. Put the radios in the charger as indicated. 5. The charging LED will turn on if it’s properly

inserted and charging.

It will take about 18 hours to fully charge the batteries. Make sure that the unit have been charged for that period the first time.

8.2 Plug in charger

Instead of using the desktop charger you can connect the power adapter plug of the power adapter directly to the headset/charging socket on top of the walkie talkies.

ENGLISH

OFF ON

Topcom Twintalker 7000 5