Cocoon 300

Press the Programming key .

You hear a confirmation tone. The new PIN code has been set.

Caution : Do not forget your personal PIN code. If you do, you have to restore the default settings (reset – see section 4.30).

4.23Subscribing a handset to a Cocoon 300/350, Butler 1000, 1010, 1210 base unit In order to be able to make and receive telephone calls, a new handset has to be subscribed to the base unit. You can subscribe 5 handsets to one base unit. By default, each handset is subscribed as handset 1 on the base unit upon delivery (base unit 1).

!!!You only need to subscribe the handset if: !!!

the handset subscription has been removed from the base unit (e.g. for reinitialisation)

you want to subscribe a different handset to this base unit.

The underlined procedure is only applicable to a Cocoon 300/350, Butler 1000, 1010, 1210 handset and base unit!!

Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator

on the base unit begins to blink rapidly. The Line/Charge indicator will blink rapidly for one minute. During this minute, the base unit is in subscribing mode and you must do the following to subscribe the handset:

Press the Programming key .

Press the Up or Down key repeatedly until ‘BASE SUB’ appears on the display.

Press the Programming key .

‘BASE _‘ appears on the display.

Enter a number of the base unit you would like to subscribe the handset to (1-4). Use the number keypad.

Note: Each handset can be subscribed to 4 different DECT base units. Each base unit is assigned a number from 1 to 4 in the handset. When you subscribe a new handset, you can assign a base unit number. It is best to use ‘1’ .

‘SEARCHING’ and the symbol appears on the display.

The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal sounds when the handset has found the base unit.

Press the Programming key .

‘PIN’ appears on the display.

Enter the 4-digit PIN code of the base unit in (default PIN code is ‘0000’). Use the number keypad.

Press the Programming key .

The handset is subscribed to the base unit.

4.24Subscribing Cocoon 300 handset on Butler 575/575+ & Cocoon100/100+ & Butler 2000 base unit

Press the Paging key on the Butler 575/575+ or Cocoon100/100+ or Butler 2000 base unit for +/- 15 seconds until you hear a beep. The base unit is now in subscribing mode. For 1

minute, the base unit is in subscribing mode and you have to do the following to subscribe the handset:

• Press the Programming key .

• Press the Up or Down key repeatedly until ‘BASE SUB’ appears on the display.

66

Page 65
Image 65
Topcom COCOON 300 manual Cocoon