Toro 13AX60RH744, 13AX60RG744 manual Tire Pressure, AttachingTheSeat, ShippingBraceRemoval

Tire Pressure

inflation pressure shown on the sidewall of the

_. WARNING: Never exceed the maximum tire.

The tires on your unit may be over-inflated for shipping purposes. Reduce the tire pressure before operating the tractor. Recommended operating tire pressure is approximately 10 p.s.i for the rear tires and 14 p.s.i, for the front tires. Check sidewall of tire for maximum p.s.i.

AttachingTheSeat

1.Remove the two knobs from the bottom of seat.

2.Position the shoulder screws (found on the base of

the seat) inside the slot openings in the seat pivot bracket.

3.Slide the seat slightly rearward in the seat pivot bracket, lining up the rear slots in the pivot bracket with the remaining two holes in the seat'sbase.

4.Select desired position for the seat, and secure with the two knobs removed earlier. See Figure 3.

....."Screws

Figure 3

ShippingBraceRemoval

engine is off, set the parking brake and

_. WARNING: Make sure the riding mower's remove the ignition key before removing the

shipping brace.

Locate the shipping brace, if present, and warning tag found on the right side of the cutting deck. See Figure 4.

While holding the discharge chute with your left hand, remove the shipping brace with your right hand by grasping it between your thumb and index finger and rotating it clockwise.

Figure 4

WARNING: The shipping brace, used for packaging purposes only, must be removed and discarded before operating your riding mower.

WARNING: The mowing deck is capable of throwing objects. Failure to operate the riding mower without the discharge cover in the proper operating position could result in serious personal injury and/or property damage.

11