Starting the Engine
WARNING: Do not operate the tractor if the interlock system is malfunctioning. This system was designed for your safety and protection.
NOTE: Refer to the TRACTOR
•Insert the tractor key into the ignition switch module.
•Place the PTO (Blade Engage) knob in the disengaged (OFF) position.
•Engage the tractor’s parking brake.
•Activate the choke control.
•Turn the ignition key clockwise to the START position. After the engine starts, release the key. It will return to the NORMAL MOWING position.
IMPORTANT: Do NOT hold the key in the START position for longer than ten seconds at a time. Doing so may cause damage to your engine’s electric starter.
•After the engine starts, deactivate the choke control.
NOTE: Do NOT leave the choke control on while operating the tractor. Doing so will result in a "rich" fuel mixture and cause the engine to run poorly.
Stopping the Engine
WARNING: If you strike a foreign object, stop the engine and remove the key. Thoroughly inspect the machine for any damage. Repair the damage before restarting and operating
•If the blades are engaged, place the PTO/Blade Engage knob in the disengaged (OFF) position.
•Position the throttle/choke control between half- throttle and the FAST (rabbit) position
•Turn the ignition key counterclockwise to the STOP position.
•Remove the key from the ignition switch to prevent unintended starting.
Using the Deck Lift Lever
To raise the cutting deck, move the deck lift lever to the left, then place it in the notch best suited for your application. Refer to Setting The Cutting Height earlier in this section.
Driving The Tractor
WARNING: Avoid sudden starts, ex- cessive speed and sudden stops.
WARNING: Do not leave the seat of the tractor without first placing the PTO/Blade Engage knob in the disengaged (OFF) position, depressing the brake pedal and engaging the parking brake. If leaving the tractor unattended, also turn the ignition key off and remove the key.
•Briefly depress the brake pedal to release the parking brake. Move the throttle lever into the FAST (rabbit) position.
•To travel FORWARD, slowly depress the upper portion of the drive pedal forward until the desired speed is achieved. See Figure 6.
Brake Pedal |
Drive Pedal |
Figure 6
•To travel in REVERSE, check that the area behind is clear then slowly depress the lower portion of the drive pedal with the ball of your foot (NOT your heel) until the desired speed is achieved. See Figure 6.
IMPORTANT: Do NOT attempt to change the direction of travel when the tractor is in motion. Always bring the tractor to a complete stop before pivoting the drive pedal from forward to reverse or vice versa.
16
