Manuals / Toro / Household Appliance / Smoke Alarm

Toro 212 manual Installation, Mounting The Controller

Models: 212

1 36

Download 36 pages 28.45 Kb

Page 24

Installation

Installation

Note: The GreenKeeper 212 controller is not weather resistant and must be installed indoors or in a pro- tected area.

For outdoor installation, a weather-resistant outdoor cabi- net is available. Order model number GK212-CAB-01 for domestic controllers or GK212-CAB-02 for export controllers.

Mounting The Controller

1.Select a location for the controller within 4' (1.2m) of an electrical outlet to enable the transformer wires to easily reach. Make sure the outlet is not controlled by a light switch.

2.Remove the mounting bracket attached to the back of the controller housing by pulling the lower edge of the bracket away and downward from the controller housing.

3.Place the mounting bracket (A) against the wall align- ing the top edge at about eye level. Drive three 1" (25mm) wood screws (B) into the wall through the three holes provided in the bracket.

Note: If you are installing the bracket on drywall or masonry, install screw anchors (C) to prevent screws from loosening.

4.Optional - Insert 3/4" (19mm) PVC conduit (D) for

22valve wiring into bracket sleeve (E).

A

F

B

C

E

D

5.Align the slotted openings on the back of controller housing with the mounting bracket tabs. Slide the controller downward to engage the tabs.

Note: After installation, store the Quick Reference Guide and the Watering Schedule Form in the pocket (F) behind the controller.

Image 24

Toro 212 manual Installation, Mounting The Controller

Contents

GreenKeeper 212 Features 4 Start Times Per Program Battery Back-UpAutomatic Pump Start Seasonal Run Time Adjust Rain Delay Rain Sensor ReadyPage Table of Contents Introduction and Set UpInstallation Service and SpecificationsGreenKeeper 212 Introduction and Set Up Controller ComponentsBATTERY GreenKeeper 212 Components 1 - LCD Display2 - Control Buttons Control Dial Positions3 - Control Dial Positions continued Controller ComponentsBATTERY Controller ComponentsSprinkler System Basics ValveHouse ValveWatering Program Diagram Watering Program BasicsProgram Starts - 5 00 AMWatering Program Details Selecting Watering DaysCalendar Schedule Odd/Even ScheduleSetting The Station Run Time Selecting Program Start TimesFlashing Planning Your Watering Schedule Guidelines For WateringFilling Out The Watering Schedule Form Page 1 2 3 4 5 Watering Schedule FormPROGRAM A PROGRAM BProgramming Before Installation Installing The Battery1. Slide the lower housing Selecting Optional Features 15-SecondRun DelayAbout The GreenKeeper 212 Memory 24-HourClock ModeResetting The Controller Memory To Reset The Permanent Program FigureTo Clear The Memory Figure Programming The Controller Setting The Current Time and Day or DateSetting The Watering Day Schedule Setting A Calendar ScheduleSetting An Interval Schedule Setting An Odd or Even Schedule Turning Off A ProgramSetting Program Start Times Setting Station Run Times Installation Mounting The ControllerConnecting The Valves WireStation Valve CommonConnecting A Pump Start Relay Connecting The TransformerOptional either terminalConnecting A Toro Rain Switch OptionalController Operation Automatic OperationManual Operation Starting Programs and/or Stations ManuallyWatering Control Features To Cancel WateringTo Resume Watering when paused To Adjust The Station Run TimeUsing The Rain Delay Feature Turning Off The GreenKeeperUsing The Season Adjust Feature Service and Specifications Replacing The Fuse Adding A Station ModuleTroubleshooting SymptomPossible Cause RemedySpecifications WarrantyPower Specifications, Domestic Model Power Specifications, Australian ModelElectromagnetic Compatibility