Toro DT34, DT54 specifications Nozzle Trajectory Adjustment Procedure

Nozzle Trajectory Adjustment Procedure _______________________________________

Note: The nozzle trajectory is factory pre-set at 25 degrees.

1.Insert the multi-purpose tool (P/N 995-83) into the slot provided in the top of the cap. Pull the riser assembly up, then grasp the assembly to hold it in the popped-up position.

2.Remove the cap retaining screw and cap.

3.Using a 5/8" nut driver (P/N 995-99), turn the nozzle/housing assembly left to select 15° trajectory as shown in Figure 4. Turn the nozzle/housing assembly right to select 25° trajectory as shown in Figure 5.

4.Install the cap making sure the top the nozzle housing is correctly nested in the cap.

5.Install the cap retaining screw.

6 Activate the sprinkler to check the spray trajectory.

Figure 5

Figure 5

5