Mixing Instructions
1.Fill an approved fuel container with half of the required amount of gasoline.
2.Add the proper amount of engine oil to gasoline.
3.Close container and shake to mix oil with gasoline.
4.Add remaining gasoline, close fuel container, and remix.
IMPORTANT!
Spilled fuel is a leading cause of hydrocarbon emissions. Some states may require the use of automatic fuel
After use
•DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an approved fuel storage container.
Storage - Fuel storage laws vary by locality. Contact your local govern- ment for the laws affecting your area. As a precaution, store fuel in an ap- proved, airtight container. Store in a
IMPORTANT!
Stored fuel may separate. ALWAYS shake fuel container thoroughly be- fore each use.
Filling the Fuel Tank
WARNING!
Minimize the Risk of Fire
■■NEVER smoke or light fires near the engine.
■■ALWAYS stop the engine and allow it to cool before refueling.
■■ALWAYS Wipe all spilled fuel and move at least 3 meters (10 feet) from the fueling point and source before starting.
■■NEVER place flammable material close to the engine muffler.
■■NEVER operate the engine with- out the muffler and spark arrester screen in place and in good working condition.
■■FUEL IS HIGHLY FLAMMABLE.
■■ALWAYS store gasoline in a con- tainer approved for flammable liquids.
■■ALWAYS inspect the unit for fuel leaks before each use. During each refill, check that no fuel leaks from around the fuel cap and/or fuel tank. If fuel leaks are evident, stop using the unit immediately. Fuel leaks must be repaired before using the unit.
■■ALWAYS move the unit at least 3 meters (10 feet) away from a fuel storage area or other readily flam- mable materials before starting the engine.
1.Place the unit on a flat, level surface.
2.Clear any dirt or other debris from around the fuel filler cap.
CAUTION!
Slowly remove the fuel cap only after stopping the engine
3.Remove the fuel cap, and fill the tank with clean, fresh fuel.
4.Reinstall the fuel filler cap and tighten firmly.
5.Wipe away any spilled fuel before starting engine.
Starting Procedure
IMPORTANT!
Engine ignition is controlled by a
WARNING!
The attachment will operate immediately when the engine starts, and could result in possible serious injury. Keep movable parts of the attachment away from objects that could become entangled or thrown, and surfaces that could cause loss of control.
WARNING!
Never start the engine from the operating position.
The cutting attachment will move when the engine accelerates!
8
