Manual Watering
The Manual Watering functions are used for additional watering if the irrigation program is not sufficient. They can also be used to troubleshoot each station for proper operation. Pressing the Manual Watering Key will access three manual irrigation functions;
Multi-Manual Station Activation Directions
Manual station activation example: Activate stations
Note: The
1. Press the Manual Watering Key .
2. | The cursor should be located in the Manual field, use the Input Dial |
| to select |
| |||
|
| ||||||
3. | Press the Down Arrow | to advance the cursor to the Sta#: field. Use the Input Dial |
|
| to select | ||
|
the correct value of the first station being irrigated. For this example, select station 01.
4.Press the Right Arrow to advance the cursor to the next value. This value will indicate the last station of the range. If irrigating only one station, this value should be the same as the first value. For this example, select station 12.
5.Press the Right Arrow to advance the cursor to the next entry field. This entry field will indicate the
runtime in hours, minutes and seconds (HH:MM:SS). Use the Input Dial |
| and the Right Arrow Key |
|
to select the appropriate runtime value. For this example, set the value to 00:05.
6.Press the Down Arrow to advance the cursor to the next entry field. Notice that a new Station: line was created. Fill this line only if irrigating multiple ranges of stations, otherwise, leave this line blank.
7. Press the Down Arrow | to advance the cursor to the Simult: field. Use the Input Dial |
| to select |
|
the maximum simultaneous irrigating stations. For this example, set the value to 03.
8.Once finished, press the Start Key to activate or press the Home Key to cancel and revert back to the default display.
Note: Pressing the Home Key will save the entered values. When finished, the display should read:
Manual: M-Manual
Sta#: 01-12 00:05
Sta#:
Simult: 03
Press START to water
14